1. Welcome To GMTruckClub.com!

    The #1 Chevy Truck Forum Online
    Online since 2004, we are the #1 Chevy Truck & SUV forum and user community. If you have any questions about your Chevy or GMC Truck, SUV or Crossover, or just want to connect with other GM owners and enthusiasts around the world, you've found the best place on the internet to do that.

    Join Today ~ It's Free
    Registering is Free and Easy! Hope to see you on the forums soon!

Torque specs

Discussion in 'General Chevy & GM Tech Questions' started by cao88c, Jul 14, 2009.

  1. cao88c

    cao88c New Member

    Hey guys,

    I need the torque specs for the Idler pulley and the tensioner on a 1999 suburban 5.7.

    Thanks
  2. Z71_guy

    Z71_guy New Member 1000 Posts 100 Posts

    i go like this

    ratchet tightening i say click then i know it tight enough :)
  3. Jimmiee

    Jimmiee New Member 1000 Posts 100 Posts

    It's all in the wrist. :)
  4. bry2500

    bry2500 New Member 1000 Posts 100 Posts

    1/4 turn past stripped.

    just kidding

    from procedure book.

    To Remove:

    [​IMG]

    1. Remove the drive belt.
    2. Remove the tensioner mounting bolt.
    3. Remove the drive belt tensioner assembly.
    To Install:
    1. Position the tensioner on the engine.
    2. Install the mounting bolt.
      • Tighten to 37 ft lbs (50 Nm)
    3. Install the drive belt.
    To Remove:

    [​IMG]

    1. Remove the drive belt.
    2. Remove drive belt idler pulley bolt.
    3. Remove drive belt idler pulley.
    To Install:
    1. Install drive belt idler pulley and bolt.
      • Torque to: 37 ft. lbs. (50 Nm)
    2. Install the drive belt.
    Last edited: Jul 14, 2009
  5. Tunnelmotor99

    Tunnelmotor99 New Member

    Tighten it to german specs: Gutentight! And remember, cross-threaded bolts hold better than thread-locker!

Share This Page