trailer brake controller

Discussion in 'Towing & Trailer Tech' started by freddie, Jan 24, 2013.

  1. freddie

    freddie Rockstar 100 Posts

    I tried to look up the answer to my question but couldnt find it. On my 03 Avalanche Z71 with 7-way plug, can i just plug in some where my trailer brake controller or do i have to do some wiring? If so where do i plug it in and could someone post some pics so i could better understand? Thanks
  2. RayVoy

    RayVoy Epic Member 5+ Years 5000 Posts

  3. freddie

    freddie Rockstar 100 Posts

    I tried looking in the manual but it wasnt any help to me. I did find i have a fuse in my #2 stud which lead me to believe that maybe i did have a quick connection somewhere under the dash and not just the wire hanging. I will just have to look to see if i see the wires latter. I just dont know where the connection would be if it had a plug in somewhere.
  4. jake's silverado

    jake's silverado Epic Member 5+ Years 500 Posts

    here you go see if this helps...

    Installation:The Chevrolet Avalanche specific adapter has one end that plugs into the back of the brake controller while the other end plugs into the port in the black box located under the dash.
    Note: If your Chevrolet Avalanche has a factory installed hitch and 7-way connector, then all of the wires for the brake controller have already been run. If not, additional parts will be required to complete the installation of the brake controller.
    Tekonsha Prodigy Brake Controller 90185 with Adapter 3015P

Share This Page

Newest Gallery Photos