1. Welcome To GMTruckClub.com!

    The #1 Chevy Truck Forum Online
    Online since 2004, we are the #1 Chevy Truck & SUV forum and user community. If you have any questions about your Chevy or GMC Truck, SUV or Crossover, or just want to connect with other GM owners and enthusiasts around the world, you've found the best place on the internet to do that.

    Join Today ~ It's Free
    Registering is Free and Easy! Hope to see you on the forums soon!

Wheel Hub Assembly w/ Bearings

Discussion in 'Chevy Silverado Forum (GMC Sierra)' started by Steelo1, Feb 25, 2013.

  1. Steelo1

    Steelo1 New Member

    I have searched on here, but couldn't find anything. Anyway, I am looking for a wheel hub assembly with bearings for an 07 Silverado 1500 LTZ 4x2. Does anyone have a recommendation or a part number? It seems there are a lot of choices, and the ones from GM seem to be starting in the $200 range for just one.
  2. shibby2oo8

    shibby2oo8 Member 2 Years 100 Posts

    I always go for timken, part they are based 10 mins away and part good history. With the china steel and assm its a crap shoot anymore.
  3. dsfloyd

    dsfloyd Epic Member 5+ Years ROTM Winner Gold Member 1000 Posts

    I used NAPA's. Mine was over 200 since its the whole assembly instead of just being able to replace the bearing and I have the 4wd.
  4. Steelo1

    Steelo1 New Member

    I found some good information on rockauto.com. I like Moog stuff, but I haven't heard of Timken, and AC Delco is so damn expensive.
  5. j cat

    j cat Rockstar 4 Years 1000 Posts

    surprised you have not heard of timken. these last I checked are bearings made in USA. this co. has been around as long as I can remember 40yrs . most times it is for my trailer hubs.

    all my 2000 SIL 4X4 hubs have the timken bearings . AZ has them.
  6. shibby2oo8

    shibby2oo8 Member 2 Years 100 Posts

    Moog bought out national i think, i went to try out a moog for my sisters impala and it wasnt a moog box. Year in still good. Timken cone bearings ate mostly usa but the hubsight be china, im not sure but i like timken the best and its what we used in the shop.
  7. buckmeister2

    buckmeister2 Member 1 Year 100 Posts

    If you have the bucks, go with a North American (US, Can, Mexico) producer, like Timken or ACDelco. If not, buy China and take a chance. I have replaced 8 front wheel hubs on 4 NBS and NNBS silverado 1500's, and opted for the import stuff each time. All have been fine, until the last pair I did, one of them had a bad ABS sensor, and will have to be replaced at some time. AutoZone sells them all, and you can ask where they were made before you buy. Also, most of their stuff carries a lifetime warranty.


    good luck!

    jim

Share This Page