Wireing??

Discussion in 'Chevy C/K Truck Forum' started by mr.copenhagen, Mar 12, 2007.

  1. mr.copenhagen

    mr.copenhagen Rockstar 100 Posts

    i am putting a CB radio in my truck.. my plan is to put the antennas on the sides of the tool box.. the only problem is how am i going to run the whires into the cab..should i drill a hole in the floor and run them up thru their??if i was to do that how would i seal up the hole??any help would be great :)
     
  2. 84fiero123

    84fiero123 Epic Member 5+ Years 1000 Posts Platinum Contributor

    Drill is the cleanest.

    Use a rubber gromet of the right size, and silicone it before putting it in.
     
  3. TrailLeadr

    TrailLeadr Epic Member 5+ Years 1000 Posts

    If I wasn't interested in putting new holes in my rig, I would find one of the rubber body plugs, and punch a hole in it, feed the wire through, and then silicone the wire, and plug to keep the water out.

    Otherwise I agree with 84Fiero.:cool:
     
  4. mr.copenhagen

    mr.copenhagen Rockstar 100 Posts

    ok so i should drill the hole..get like a gromit thing than i plug it??if i was to plug the hole how would the wire go thru? i know with my plow truck i just dont give a damn so idrilled a hole and left it its soo rusty i dont even have a bed their is just a huge hole in it..but i mean i want to do thisthing right bc i want to give it to my daughter someday
     

Share This Page

Newest Gallery Photos