GM Truck Club Forum banner

350

  1. I had the engine running but now it won't do anything at all...

    Chevy C/K Truck Forum
    It's a 1975 Chevy C10 With a 350 5.7L. I finally have some time and money to work on it and made some good progress the last couple days. Changed out the fuel filter, put fresh gas in, and made sure the engine could spin. It started and ran for the first time by itself (no starter fluid), and I...
  2. 1995 k1500 350 swap

    Chevy C/K Truck Forum
    So I have a very worn out 305 in my 1995 Chevy k1500. I have a rebuilt 350 although it is carburated. It's hooked up to an also rebuilt tbh350. I know what it would take to just swap the motor (fpr, TCM, TPS), but would it be worth it to just switch out the tranny also? I drive it to work and...
  3. Turning the 99 Burb into an overlanding rig

    Chevy Suburban Forum (GMC Yukon XL)
    So I've got a 99 Suburban K1500 LT with the 350 5.7. What I'm looking to do is a full drive train rebuild. I feel like I'm missing some valuable parts though and I'm looking for input on what I might need. I'm looking to turn it into an overlanding rig and to make it very dependable. I also want...
  4. 95 Chevrolet K1500 5.7

    Chevy C/K Truck Forum
    Thinking about ditching the EFI and swapping to a carb, my only setback is the 4L60e. As far as I know the only things I need is a Holley carb and throttle position sensor kit, HEI distributor, matching intake for heads and carb (edelbrock performer 2104) and a fuel pressure regulator with the...
  5. 1994 gmc 4x4 350 to 454 swap.

    Chevy Silverado Forum (GMC Sierra)
    Hey guys So I have a 94 gmc 4x4 . With the tbi injectors or throttle body. Anyways at the moment it has 206,500 on the odometer. Lately it has absolutely no guts nuts nadda I start off from the stop sign at a snails crawl.. no power .I've done spark plugs distributiter cap Rotor ,timed it...
  6. 88-98 pressure plate alignment dowel pins. NEEDED?

    Chevy C/K Truck Forum
    I got a 90 c1500 that i just finished rebuilding. Im wondering if i need the dowel pins for the flywheel to pressure plate connection. or if i have oriented right, can i just use the mounting bolts torqued to spec? Thanks
  7. 92' GMC k1500 5.7 bogging down

    Chevy C/K Truck Forum
    I have a 92 GMC k1500 5.7 TBi 350, I got this truck about 6 months ago. The engine has a little over 100k miles on it so not original engine. The truck boggs down constantly but not where it cuts off, it idles great but when giving it gas it runs like it's lost half the power. Every now and...
Top