GM Truck Club Forum banner
1-6 of 6 Results
  1. GM Vehicle Classifieds
    Lots of new parts. Will still need some minor attention. Well taken care of. Several thousand put into it to keep it running strong. clean title. new plugs, new plug wires, new water pump, distributer cap, thermostat, tires with lots of life, 90% tread life left, brand new radiator, and much...
  2. Chevy Suburban Forum (GMC Yukon XL)
    I have a 1998 Chevrolet Suburban 5.7 vortec engine at 299000 miles. Yesterday I accidentally put in 93 gas instead of the recommended 87( not sure if this fact is related to the problem). The very next day, it suddenly cut off while driving down the hwy. I pulled over to try and restart it, it...
  3. Chevy C/K Truck Forum
    I’m working on a 1994 GMC c1500 TBI 5.7 v8. I hadn’t started it in 5 days and it started with the first turn of the key today! But after letting it idle for 10 minutes, I shut it off and when I went to start it back up it would only crank over. When I opened the throttle all the way it would...
  4. Chevy C/K Truck Forum
    I currently have a 1995 C1500 Single cab truck. The seats are in fine condition and they are 60/40 seats with a folding down middle, although it doesn't function as a console. I also have a 2001 s10 that has the type of seats I want in my Silverado, I was wondering if my seats from the S10 would...
  5. Member Introductions
    Hi y’all, I came across a 92 c1500 Cheyenne with a bad dent on the driver side door, my question is are the doors interchangeable with any other GMC models? If so which ones. Thanks in advance
  6. Chevy C/K Truck Forum
    Hi all, I’m currently installing a CB radio in my 1994 C1500, and I need to wire the coax antenna cables through the firewall. Are there any preexisting holes or grommets that I could piggyback off of, or would I need to drill a hole? I want to do as little collateral damage as possible...
1-6 of 6 Results