GM Truck Club Forum banner
chevy c/k1500
1-13 of 13 Results
  1. Chevy C/K Truck Forum
    Sorry guys I’m new to using a forum like this, I have a 95 extended cab Cheyenne 2wd. 350 carbed motor with a 5spd man. I’m looking to keep it stock height but add some bigger wheels and tires. It sits on 15s now which I despise to be honest so I want to buy some black 16” wheels but I’m not...
  2. Chevy Silverado Forum (GMC Sierra)
    Hello all, I’m by no means mechanically inclined but after having done some reading in forums, I found a (fingers crossed) solution to my oil consumption problem. I replaced my drivers side valve cover with the updated version, however upon installation, I made a careless mistake. I ran a little...
  3. Chevy C/K Truck Forum
    I have a 1995 Chevy Silverado two door 2 Wheel Dr. with a 5.7 L V-8. I am having problems with my tail lights and brake light staying on together. Brake lights will not work at all until I turn on running lights or headlights then brake lights and tail lights are illuminated together. Weird...
  4. Chevy Silverado Forum (GMC Sierra)
    I have a 01 Sierra 1500 2wd that I just recently bought and no check engine light or service soon light or abs etc will go off when truck is on or when turn the key on. So I looked behind the cluster and Radom wires were soldered so I bought another from a guy and gave him my old one as a core...
  5. Chevy C/K Truck Forum
    I just got a 1993 k1500 with a 5.7 from a family member and it won’t start. There is power to the dash, windows, lights, etc... When I turn the key the pickup does not start. The oil pressure gage needle moves and the lights go dim on the dash. If you push the hazard button it will just show two...
  6. Member Garages
    My truck is a 1998 Chevy k1500 5.7 and it is idling rough when it’s warm not noticing any misfires and no engine codes other than my catalytic converters code but I have a cat delete. Anyone know what the problem could be?
  7. Chevy C/K Truck Forum
    I have a 1997 Chevy k1500 5.7vortec And it had a hornet security system 553t model.it started clicking and locking my doors and doing other funky stuff,now my truck will start and then die and I think it's because of this system shutting down fuel system.I did take it out and noticed some wires...
  8. Chevy Tahoe Forum (GMC Yukon, Cadillac Escalade)
    On my 99 Tahoe 5.7 4x4 I have had a problem with the output shaft seal having a leak. I have change the seal multiple times. This time I decided to go ahead change the bushing in tcase housing tailshaft along with the seal. And I also put a used but very good looking slip yolk on it. And I am...
  9. Chevy C/K Truck Forum
    I've got a 97 GMC K1500 short bed. Wondering if anyone has heard of or done an AWD swap? Apparently you can rob a 2002-2006 Escalade AWD of its front diff and transfer case (NV149) and its as easy as bolting in the Escalade parts onto your truck. Thoughts and ideas for making this happen is...
  10. Chevy C/K Truck Forum
    I have a 97 GMC K1500 short bed. Looking to put new box sides on it. Can only find Chevy box sides. Do Chevy box sides interchange with GMC trucks?
  11. Chevy Tahoe Forum (GMC Yukon, Cadillac Escalade)
    I have the 99 Tahoe 5.7 vortec. It’s had a problem with a hard start every time. And sometimes it will throw the code ignition coil voltage high. I changed the module out and still does it. And sometimes it runs rough and will throw bank 1 sensor 1 and bank 2 sensor 1 low voltage. The...
  12. General Chevy & GM Tech Questions
    Hi Y'all, New to the forum here so take it easy on me. I have a 1992 K1500 just handed down to me from my pops. I would like to replace the front grille. Most everything you order in regards to parts are 88-98. However, I noticed the grille part is 1994-98. There are way more options in 94-98...
  13. Chevy C/K Truck Forum
    Hello everyone so I'm planning on a project I have a '91 1500 stepside and I plan on switching the bed with '79 c10 stepside bed. I haven't seen if anyone has tried this but I personally plan on doing so, just wanted to see if anyone has ever tried or actually done this conversion. I will be...
1-13 of 13 Results
Top