Search Results for ‘engine swap’

Hey guys, I have a 1991 chevy k1500 with a 5 speed manual and old tbi 350. I ordered a blueprint engines 383, new flywheel, clutch, etc. my biggest concerns are how to utilize the stock electric fuel pump in the tank and also how to wire in the distributor. Any tips or advice would be helpful...

I'm trying to replace the engine in my truck. And had random question I'm not sure how to check. Would a 4.3l engine from an 02 silverado fit just fine in the place of a 4.3l 09 silverado? How do I check? Do I need to swap flywheel? Is it as simple as just making sure the bell housing bolts are...

I'll start by saying I've looked all over a bunch of forums including this one to find the info I need, but to no avail. I'm putting a motor in my 1994 k1500 (5.7) and have a wire that seems to have lost it's label that I now can't figure out where it goes. The wire comes out of the back of...

I have a zero milage 350 carbureted engine sitting doing nothing, I'd like to set it in my Suburban 4x4 for an Outlander. Is it possible and what do I need to change it out?

Evening everyone. I am looking for input on a build I am going to be starting. I have a 1968 Chevy C50. I am going to be dropping the cab onto a 3/4 ton pickup frame and going to be going with a twin turbo build. I am trying to source the best block setup for this. I will be going for a high...

I have a 1995 Chevrolet K 2500 with a 5.7 L 350 motor in it it ran without oil hauling a bit of a scrap lumber load and stopped on the highway I had it sitting on the property for a little while when I decided to charge up the battery and turn it over again and it did turn over but will only...

I purchased a 93 Suburban that I am extremely excited about. I am planning on turning it in to the Western hunting rig. The body is in great shape and it drives fine but it's doggy. Also, the interior needs serious help. Fortunately I have a 96 chevy truck sitting around and that has the Vortec...