GM Truck Club Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-12 of 12 Results
  1. Chevy Silverado Forum (GMC Sierra)
    Has anyone had experience with this code popping up on their truck? What is the cause and effect of this code/issue? What is the repair that you had to do? Where about on the engine is this solenoid valve located? Is it safe to drive or would I be running the risk of burning up my engine...
  2. Chevy S10 Forum (GMC Sonoma)
    I have a 2.2l 2 wheel drive 98 s10 that has recently started knocking severely. It started off being fairly small but got worse. I ended up checking the oil and it was dryyyyy, threw a couple quarts in and it's still just continued to get worse. Looking for suggestions as to what may be causing...
  3. Chevy Silverado Forum (GMC Sierra)
    Evening everyone. I am looking for input on a build I am going to be starting. I have a 1968 Chevy C50. I am going to be dropping the cab onto a 3/4 ton pickup frame and going to be going with a twin turbo build. I am trying to source the best block setup for this. I will be going for a high...
  4. Lifted & Offroad Suspension
    Hey all, I recently bought a 96 sierra k1500. The previous owner did a body, lift but didn't raise the motor. The fan shroud is not setup correctly because the engine is too low. There's a few inch gap between the upper and lower and it's causing some cooling issues at idle in hot weather...
  5. Chevy Silverado Forum (GMC Sierra)
    Recently had a lifter fail on my truck (2013 Chevy Silverado 1500, 5.3) and apparently this is very common for my engine. Does anyone know if there are active class action lawsuits for this? I found the following links below...
  6. Chevy C/K Truck Forum
    Hey all, I have a question about my 94 Z71. I got it in a trade about two years ago. I noticed that the engine had been changed out, but for what size? This all came about with my first oil change I did. I went to the parts store and got oil and filter for a '94 5.7 four wheel drive. When I...
  7. Chevy C/K Truck Forum
    I bought a 1998 Silverado 2 days ago knowing it had some “misfire” problems but I didn’t know the causes, I’ve replaced the rotor cap and rotor and nothing really changed, sometimes it take 3 cranks to start up and sometimes it fires right up. I’ve put a video of it running, it won’t go past...
  8. Chevy C/K Truck Forum
    Well I’m back, still haven’t had any luck finding a first truck but I’m back asking for thoughts on another truck I’m looking at, here are the things I noticed while test driving it, knowing it has misfires; Took 2 cranks to start up Motor shakes on idle Idles hard Shakes when shifting into...
  9. Chevy Captiva Sport Forum (Saturn Vue)
    Hello everyone! My Saturn Vue 2008 2WD XR have engine oil in the air intake hose, i want to replace the PCV Valve but not locate this in the engine, only can see the tube what connect to intake and the engine. Does anyone know the location of the pcv valve on this engine? Regards!
  10. Chevy Avalanche Forum (Escalade EXT)
    Hi everyone. I have a 2008 Avalanch with 6.0 (swapped engine) It’s started making ticking noises, I think the lifters are ticking. What I’ve noticed is the oil pressure starts to drop as long as the engine temperature increases, so I did an oil and filter change immediately. No more noise for...
  11. Chevy Silverado Forum (GMC Sierra)
    Hi. I've recently purchased a 2016 Silverado 1500 LT with the Z71 package and 3:42 rear end. The vehicle felt good during the test drive but I have noticed recently that it feels "restricted" in some way. I don't mean restricted in power, but more like the drivetrain is fighting against a...
  12. Chevy C/K Truck Forum
    It's a 1975 Chevy C10 With a 350 5.7L. I finally have some time and money to work on it and made some good progress the last couple days. Changed out the fuel filter, put fresh gas in, and made sure the engine could spin. It started and ran for the first time by itself (no starter fluid), and I...
1-12 of 12 Results
Top