GM Truck Club Forum banner
1 - 2 of 2 Posts

·
Registered
2001 Suburban 5.3L, 300.2k miles
Joined
·
1,798 Posts
On the beam type front axle, it looks like the camber is fixed by the king pin angle.
I don't see any adjustment.
If the camber is out of spec, look at inspecting the lower and upper king pin if they have bushings. It there is visible bushing wear, replace them to bring the camber to specs.
The king pinsneed to be lubed with grease on a regular basis to minimize wear
Automotive tire Bicycle part Font Crankset Auto part
 

·
Registered
2001 Suburban 5.3L, 300.2k miles
Joined
·
1,798 Posts
My front tire tread is wearing on the outside, Planning to replace tires and shocks and air them up to 70-80psi and should be good for another 40k at least.
At least get an alignment to get the toe adjusted when you buy new tires.

Check the tire pressure sticker on the B pillar for the correct tire pressure.

If you have load range E tires, go to a truck scale and get the axle weights and adjust tire pressure based on each tire load.
 
1 - 2 of 2 Posts
Top