GM Truck Club Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
I recently purchased a 97 K1500 with the push button 4 wheel drive. About two months ago when I first bought the truck the 4 wheel drive was working fine, then one day I noticed the 2 wheel drive light on the button looked a little dim and when I pushed it the light went out completely. Sometimes when I start the truck the light is on and other times it isn't. However, the last few times the light has been on it has been very dim and will not engage into 4 wheel hi or low. Has anyone had this problem? Im not to familiar with the push button system. Any help would be greatly appreciated! Thanks
 

·
Registered
Joined
·
221 Posts
X2 or Rich50's post. Also, climb underneath and check all the wire connections, including your dash switch. Loose wires could cause EVERYTHING to not work.
 

·
Registered
Joined
·
3 Posts
Discussion Starter #5
Thanks! Unfortunetly I replaced my dash switch and that wasn't the problem. I will crawl under and check the actuator and look for loose wires.
 
1 - 6 of 6 Posts
Top