GM Truck Club Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
6,394 Posts
disconnect the wiring you worked with this on these power sockets. also look for any wiring damage caused by the steel cutting into the wires..

then try putting a fuse back in. if the fuse does not blow then you can get codes and end those other issues.

disconnect the battery FIRST>>..
 

·
Registered
Joined
·
6,394 Posts
THE wire color used is typically set to certain circuits. so if you connected a blue to an orange this may cause the problem. since this fuse blows and power is always on these sockets you could also have bad socket ...so remove these and see if the fuse stays good...

a wiring diagram would be good but you altered the wiring so I would undo what you did...
 
1 - 2 of 2 Posts
Top