GM Truck Club Forum banner
1 - 1 of 1 Posts

· Registered
14 Posts
Discussion Starter · #1 ·
When it stopped working about 1-1/2 years ago, it did so very gradually luckily stopping in the closed position. Since then, it hasn't worked again. I'm suspecting a motor problem rather than a circuit or switch. Has anyone dealt with this? Where's the motor located? What's the part run pricewise? If anyone has a pdf of the layout, I'd appreciate it.

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.