GM Truck Club Forum banner
1 - 7 of 7 Posts

· Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I Have a 2008 chevy Silverado Crewcab pickup it has a 8in lift in the front and 6in in the rear with 35 inch nito tires and a ranch hand bull
guard on the front.
Land vehicle Tire Vehicle Car Automotive tire

The transmission temp has been running from 180 to 210 since the temperatures in Ks are now above 100 almost everyday. this seems like its to hot since im not pulling anything. I want to install a transmission cooler to help lower these temps since the stock one just doesnt seem to handle this. I am not sure about which one I should get. Any suggestions would be great.
 

Attachments

· Super Moderator
Joined
·
4,756 Posts
I Have a 2008 chevy Silverado Crewcab pickup it has a 8in lift in the front and 6in in the rear with 35 inch nito tires and a ranch hand bull
guard on the front.
View attachment 28784
The transmission temp has been running from 180 to 210 since the temperatures in Ks are now above 100 almost everyday. this seems like its to hot since im not pulling anything. I want to install a transmission cooler to help lower these temps since the stock one just doesnt seem to handle this. I am not sure about which one I should get. Any suggestions would be great.
:sign0016:To the Site......I just install a aftermarket Transmission Cooler, to replace the factory Transmission Cooler....as my transmission Temps were running at the same Temps you've Mentioned....Below is my thread with information on the aftermarket Trans Cooler I installed in my Truck,

Link,
http://www.gmtruckclub.com/forum/showthread.php?70799-New-Transmission-Cooler...WOW
 

· Registered
Joined
·
7,267 Posts
Welcome to the club.
 

· Registered
Joined
·
8,697 Posts
Welcome to the club SP
 

· Registered
Joined
·
250 Posts
Should a new cooler be added inline with existing factory cooler, or replace? Considering factory warranty is still in effect.
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top