GM Truck Club Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter · #1 · (Edited)
I am trying to replace the 4wd actuator motor on my 2003 suburban. I have very little mechanic experience but am not afraid to try! I got the old one off (with a bit of finesse). I can not get the new one into place. There is a drive shape/gear box thing which is in the way of getting the new actuator seated properly. I can not manuver the female part of the acutator over the male gear which protrudes from the car. Any help would be greatly apprecaited.

T
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top