Nothing done with getting it running again yet. Waiting for the tranny to get done. I did pick up a set of 16" steel rallies for it though. The fun part will be boring out the center hole to clear the hub. They currently measure 3" and I need them in the ballpark of 3 5/8" to clear the 3 1/2 locking hubs... :/ any tips are appreciated
90 burban
Ok. This is definitely going to be a slow project. I picked up this V1500 yesterday with a loose connecting rod in the 350 for $500. 0 rust that I have found. Gonna give it a bath a start yanking the motor for the 72ish corvette engine. Bought it from my bosses son in cortez and drove it to Delores. In that 10minute drive I made it a lot worse lol as I was nearing the driveway, the rod decided it wanted out and put a hole in the oil pan trying to find its way there lol! Sounded like a 14yro kid jerking off against a tin shed!
I'll take more photos after I get it cleaned up!
I'll take more photos after I get it cleaned up!
Attachments
1 - 6 of 9 Posts
By god progress has been made! Got the tranny welded up today
Attachments
Well. This project has been flushed. Went to work on a truck that already runs and I can't afford 2.
Meet "the turd"
Meet "the turd"
Attachments
1 - 6 of 9 Posts
