[jfsjr92]

so, i am new to chevy trucks and i am going to get a 95 k1500 z71 w a 350 w a edlebrock 550 carburetor on it and lunati roller rockers. it also has long tube headers and a catback. anyways, the front driveshaft was taken off for the long tube headers to fit. but id rather run shortys and have 4wd. so....what driveshaft do i need. i see the ones that fit the 4L60E....(or whatever they are called) but what about the 350 turbo? any help is appreciated. thanks.

 

[2COR517]

What's the transfer case? Is it even a driver's side drop case?

 

[jfsjr92]

um, the guy it said it is the stock transfer case.... idk what that would be

 

[2COR517]

Would likely be an NP241. If they used the stock rear driveshaft, you could use a stock front driveshaft. I don't know offhand if the TH350 is the same case length as the 4L60 or not, but I think so.

Gas mileage is going to suck without OD.

 

[jfsjr92]

yea it is :/ a buddy of mine does have a spare 350 and a transmission for it that i can get. not sure of what transmission it is, but if it has over drive i might get it. whats the pros of the 350 turbo?

 

[2COR517]

...whats the pros of the 350 turbo?

Simplicity