GM Truck Club Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
10 Posts
Discussion Starter · #1 ·
Ok guys I have 199 Chevy Silverado.

Compressor clutch won't engage and oil is spraying out of the sides where the pulley is. I am planning on getting a new compressor and dryer.

My question is do I need a new condensor also?
 

· Registered
Joined
·
8,697 Posts
No, there shouldn't be any problem with the condenser. You might be able to get by with just a new compressor seal, & replacing the oil that was lost. The compressor crank seal usually just starts leaking slowly & then gets progressively worse over time. Seals usually don't blow out unless the system was overcharged. Did you have the AC recharged recently?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top