GM Truck Club Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
233 Posts
most likely the resistor, pull the blower motor out, (under pass. kick panel) you may have to remove other plastic covers to get to it, once removed, look right behind the motors fan housing is and youll see it there, usually, 3 8mms on the motor, and 2 on the resistor, 1/4" ratchet, and an extension are usually the best tool. Good Luck!
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top