GM Truck Club Forum banner
1 - 1 of 3 Posts

· Registered
7,267 Posts
It just peels off. Its a little trickie getting started but just pull slowly. It WILL leave some 3M tape. You can get a 3M eraser wheel and 3M adhesive remover at most auto parts stores. Wash the area with soapy water to clean dirt that collects under the molding, than use the eraser wheel and finish with the adhesive remover, then wax area. If you don't like using the eraser wheel than you can peel off the tape after soaking with the adhesive remover. This does take alot of time and kills your fingers. Get the eraser wheel.
1 - 1 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.