GM Truck Club Forum banner
1 - 1 of 3 Posts

· Super Moderator
4,756 Posts
I was wanting to know how to get the body molding off my door panel. anyone done this? is it somethign they can do at dealership easier?
There are a Couple of Ways to Remove the Door Trim....I Did & Used the Following items,

1. .....A Heat help Soften the Trim

2. .....Fishing line Between the Body & the Trim......and in a Sawing Up and Down Motion

3 .....Once I Removed Half of the Trim....I Gently Pulled the Remaining Trim Off

4. .....I used a 3M Eraser Wheel to remove the left over could also Use Goo Gone to Remove the Adhesive

5. ......Wash the Area down and Then a Coat of Wax

6........Last Take your Time
1 - 1 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.