GM Truck Club Forum banner
1 - 12 of 12 Posts

·
Registered
Joined
·
992 Posts
with a 2" spacer you will be fine my brother got his 2007.5 not to long ago and the prevs owner had it on pretty much since new and he never had to replace anything and your stock shocks are fine
 

·
Registered
Joined
·
593 Posts
Will parts wear faster with a leveling kit? Yes. Could take months...could take years. Or you may not have a single issue before you trade/sell. It just depends on the truck and the operator. Don't sweat it.
 

·
Registered
Joined
·
7,291 Posts
The extra wear is so little you won't notice. I know guys that had to replace balljoints on a stock 40,000 mile truck. My '05 with 6" lift, 35"tires and 89,000 plus miles has the stock balljoints.
 

·
Registered
Joined
·
26 Posts
Discussion Starter · #5 ·
thanks! thats what i was wanting to know. from what i read about 80% of people say there are good for a cheap lift and about 20% of people say they are no good.

---------- Post added at 09:14 AM ---------- Previous post was at 09:10 AM ----------

oh another question. I see spring spacers on ebay- that are cheaper. Are those any good? Is it possible to like "mess up" a spacer and make it bad quality? Would you buy one?
 

·
Registered
Joined
·
992 Posts
Ya i learned that the hard way blackedout when i went with roughcountrys 3inch kit
 

·
Registered
Joined
·
992 Posts
If i knew now what i did when i start working on my truck i would of saved alot more money
 

·
Registered
Joined
·
992 Posts
Didnt the 2001 have torsion bars
 
1 - 12 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top