GM Truck Club Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
3,441 Posts
Discussion Starter · #1 · (Edited)
I blew out the bearing in the drivers side CV Axle, anybody have any tricks to changing one, I dont have the correct tools to remove the tie rode and i dont want to torch it and ruin anything else that i dont need to replace, i want to do this myself as i really dont want to pay $75+/hr for shop labor. i have a chilton manual and the illustrtions are crap.
 

· Registered
Joined
·
3,441 Posts
Discussion Starter · #3 ·
ok got everything but i before i take this thing apart will i even be able to break the axle/hub nut loose the manual says its torqued to 165 ftlbs, i dont have any air tools or are they available
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top