GM Truck Club Forum banner
1 - 1 of 1 Posts

· Registered
8,700 Posts
I had to order a micro tool set to get a 1/8" nut driver to disassemble the radio to replace a couple of bulbs in there so it's sitting on my table in pieces. The wife just loves that.
LOL... Soooo what's she going to say when you have the dirty greasy cylinder heads on the table doing a valve job? :rofl:
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.