The engine light will not turn off on my 2000 suburban. It only stays on when the weather is below 50 degrees. A mechaninc said I could have gotton some bad gas and I ran the tank almost dry and that did not work. Any help would be appreciated.
engine light
1 - 2 of 2 Posts
1 - 2 of 2 Posts
Join the discussion
Recommended Reading
-
wheel stud Replacement
Chevy Suburban Forum (GMC Yukon XL)im having trouble installing the wheel studs. i saw alot of videos and all most of them did not have the same trouble i ordered online the set 610_434 the old ones are marked M 6177 on the studs. Am I installing the wrong ones?- 2
- 68
-
05suburban · updated
-
Electrical Issue
Chevy Suburban Forum (GMC Yukon XL)Hi all, I have a 2009 chevy suburban LTZ. Even though it is the LTZ model it didn't come with the DVD player or back up camera/navigation system so we bought a DVD player for it and had it installed. Recently I've noticed that while accelerating it will cut off for a brief second and everything...- 1
- 42
-
aandspowell · updated
-
Will my 5.7 motor "break" before 300,000 miles??
Chevy Suburban Forum (GMC Yukon XL)OK, I know there is no way to actually know, but folks out there have lots of experience, so I'm looking for best guess. I've only had one motor actually "break" enough to leave me on the side of the road, and that was a 1964 MG1100 that I was running at full throttle(84 mph) in 1967.There...- 26
- 24K
-
2005 Chevy Suburban 1500 a/c blows hot driver side, cold passenger
Chevy Suburban Forum (GMC Yukon XL)I know I've seen this discussed here before but I can't find it! I noticed the a/c wasn't cooling quite as well as it had been, then the next day ( of course the hottest day here so far, Arizona ) it wasn't cooling at all. So of course I added a can of freon! Well, it blows cold on the passenger...- 1
- 41
-
Bleeder valves stuck shut
Chevy Suburban Forum (GMC Yukon XL)OK I have a 99 K2500 4x4 Suburban with 195,000 miles on and it started pulling to the right pretty hard so I first decided to replace front calipers and pads, simple. When I went to bleed the back brakes, both bleeder valves are stuck on itght where I can not get them cranked open! I am open to...- 9
- 244
Join now to ask and comment!