GM Truck Club Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I have a 1995 4 X 4 Suburban with a 5.7 engine. When I apply my brakes the gas gauge will swing wildly and end up either at the full position or empty position. I'm thinking of replacing the stepper motor, but I'm trying to see if there's anything else that might be the cause of this.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top