GM Truck Club Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
I was going to crank my torsion bars up about 1" to 1 1/2"s to make the front end a little more level and was wondering where would be the best place to measure from to make sure I get both the left and right sides even with each other? Also, should I jack the truck up to turn the screws or can I do it while it's on the ground?

Thanks
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top