GM Truck Club Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
561 Posts
you can hold the wire to the frame (clean unpainted metal and have someone turn the key and the pump should try and prime if all the connections are correct. if you migh have tugged the connections inside the tank and need to open and reconnect, but to verify this us a jumper battery or some long wires from the battery and goto the connector for the tank and see if it runs......i seen the connector that goes thur the tank go bad. if it is this part it is no longer avalable from chevy. i just soldered the wires and used heat shrink and then a rubber grommet and some silicon on both side of the plate and all been fine.....that was fixed 3 years ago..........mike
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top