GM Truck Club Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter · #1 ·
Ok so I posted earlier that my 97 Sub would not start and was producing a "heavy crank". Turns out the Cats went out and apparently literallly melted the O2 sensors.

So I replaced the O2s (both) and also went with a magnaflow Cat forward instead of an OEM. This provided me better low end and was actually cheaper. My real question however is WTH caused the O2s to melt? I am running a hypertech (have it stock now) but other than that I cannot figure out what would cause this.

Any ideas?
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top