Idler arm and Pitman replacment

1293 Views 3 Replies 3 Participants Last post by Kraziken, May 10, 2011

Kraziken

Discussion Starter · May 9, 2011

I've seen some instructions online on how to replace the Idler and Pitman. Most seem to be done without a Pitman Arm puller? Would it make it easier? How about an Air Hammer? Not necessary, but again, would it make the job easier? I've never used one.

In the process of gathering parts and tools to do the job myself.

Thanks
Ken

Save

1 - 2 of 4 Posts

Kraziken

Discussion Starter · #4 · May 10, 2011

The fork kit I figure might be useful for other tasks. I ordered this one. The pitman puller does seem a bit pricey. I will ask the local parts store if they have a rental.

http://www.amazon.com/gp/product/B0002SRG4S

Save

1 - 2 of 4 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.