I am attempting to replace the idler arm on my wife's 1999, 1/2 ton, 2wd Chevy Suburban. According to a video I watched on 1A Auto.com the steps on removing it were as follows: 1. Remove the nut connecting the arm to the steering linkage. 2. Using a joint separator (pickle fork) and a good hammer insert the separator at the joint above the linkage and use the hammer to knock it loose. 3. Remove the three bolts that attach the other part of the idler arm assembly to the truck's frame. 4 Go back to where the joint and steering linkage were knocked loose, then pull the linkage down to remove the treaded part end of the idler arm and work the whole assembly out and off of the truck. I have gotten to step 2 using the pickle fork and a 3 lb. sledge I have hammered at the joint off and on for over two hours (I had to take a breather every now and then), but the joint does not separate, it just sits there laughing at me. I even removed the nut that connects the inner tie rod end to the steering linkage hoping that would help loosen the idler arm joint up. Nah, still doesn't work! What other suggestions do y'all have?:neutral:
This is an older thread, you may not receive a response, and could
be reviving an old thread. Please consider creating a new thread.
GM Truck Club Forum
A forum community dedicated to all General Motors truck owners and enthusiasts. Come join the discussion about performance, lift kits, wheels, tires, modifications, troubleshooting, maintenance, and more!