GM Truck Club Forum banner
1 - 1 of 1 Posts

· Registered
15 Posts
Discussion Starter · #1 ·
Recently my key got stuck in the ignition after my brother in law replaced the heater core for me. It will go to the start position and back to to the accy position but not the off position. Is the only solution to replace the ignition cylinder? I just wanted to make sure because I'm going to take a crack at it this weekend. And if it is any tips or advice to make the process go by quicker? Thanks for the help in advance
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.