GM Truck Club Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
I have a 1986 Gmc 1500 truck. it is 2wd with a 305 engine and a 350 transmission single cab and 8' bed.
Now on to my question- The cab corners (both) of my cab are rusted out and need to be replaced. The Rockers underneeth the door are ok. I have the replacment cab corners but am not sure how to install them and have them look good. I was wondering what the best approach for installing them would be. Weather it would be to tac weld them and bondo the rest of the gap. Or to rivit them.
Also, on the bed, in front of the tire where the bed curves under, there are rust spots, How would i go about replacing these problems?
Please if anyone would be able to help me out with either of these problems, it would be very appreciated.
Thanks!
 
1 - 1 of 1 Posts
Top