GM Truck Club Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
56 Posts
Discussion Starter · #1 ·
Working on a 1996 6.0L gas engine in a Kodiak Dump truck. Question, is it safe to a TDC stop tool to keep engine from spinning while tightening up on the balancer? Or is there another means to stop the spinning? Engine is still in the truck. I'm purchasing the install tool as all other attempts have caused cussing, yelling and the tossing of small animals.
 

·
Registered
Joined
·
56 Posts
Discussion Starter · #3 ·
Transmission is still in the truck. Drive shaft is disconnected from the rear end.
 

·
Registered
Joined
·
56 Posts
Discussion Starter · #4 ·
Do you think a "C" clamp on the flywheel would work?
 
1 - 4 of 4 Posts
Top