GM Truck Club Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
80 Posts
Discussion Starter #1
well i am looking into adding a lift soon, i am looking for input. i have a 96 4x4 1500. I wanna run at least a 35's. any ideas on sizes and brands would be greatly appreciated.
 

·
Registered
Joined
·
7,291 Posts
You will need a 6" lift for the 35's and depending on wheel offset and width you may have to do a little bumper trimming. I have a 6" Rancho on my '96 'burb since '97 and no issues. I had a ProComp on first when 'burb was new and it was junk. Removed after a year and installed the Rancho. The Rancho has a 1-piece welded sub-frame and the upper control arm brackets are cusseted. I have a set of the original MickeyThomspon Alcoa forged wheels, 16x10 and had to trim the bumper just a little.
 
1 - 2 of 2 Posts
Top