GM Truck Club Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
38 Posts
Discussion Starter · #1 ·
i have an 81 k-20 scottsdale i need to replace the front wheel bearings, and the problem i'm having is inside the manual locking hub the chiltons manual says remove the large snapring and the outer clutch (i think is what it's called) should just slide out problem is it seems to be hanging up on the groove for the snap ring and won't come out,anyone have any idea what to do??
 

·
Registered
Joined
·
38 Posts
Discussion Starter · #3 ·
thats the problem, i got the snap ring out ,what i'm having trouble with is the outer clutch assembly(i think is what it's called) the piece that the large snap ring holds in place and that the locking hub cover bolts to with the 6 allan head screws . i can't get that piece out of the housing to get to the nut that holds the rotor on.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top