GM Truck Club Forum banner

Overhead DVD

3155 Views 2 Replies 2 Participants Last post by  ChevyFan
Just purchased an overhead DVD unit from Ebay...would like to mount it just behind overhead console right over the dome light for the grandson in the back. Anyone else do this? It appears there is plenty of room to do it but was wondering about the has built in dome light that I will just connect to the old dome wires...what I am wondering I have to fish new power wires thru the console or headliner or are thier power wires already up there? Should mention I have 2001 Silverado w/4 dr & 5.3l
1 - 3 of 3 Posts
Did it

OK.........went at it anyway.....quite easy to do actually.......the only problem was getting some support under the headliner to hold it up at the front. That was taken care of by glueing a piece of wood up to the metal roof...just applied some glue to the wood and slipped it up into the dome light opening and pressed to to the roof. As for the wireing that was also pretty easy...I used the existing wires for the dome light to hook up to the dome lights in the DVD for the power I ran the wires to the drivers side of the headliner(just fished it across with coat hanger) and then to the front plastic piller on the drivers side by just putting the wire along the door gasket and putting it under the headliner and then pushing it down thru the piller cover and it comes right out at the fuse block. Go get an adaptor for the fuse block to connect power. It all works great and you can even see it in the daylight...the only drawback is that my unit has one hinge for the drop down screen and becausr it swivels 30 degees to either side it shakes a bit when time I think a unit with a hinge on both a laptop my fair better when driving.
See less See more
Would love to see a picture of that actually. Yeah, i've heard about people putting a block of wood up there to give some support and it spreads the load across a wider area on the headliner.
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.