GM Truck Club Forum banner

Pulling Left When Brakes Mashed

889 Views 16 Replies 5 Participants Last post by  Jaercole
Hello All. Have a 99 GMC Suburban K2500 4x4 7.4L. Recently had new front brakes and rotors put on. After a few months the truck pulled left when the brakes were mashed. Mechanic said I needed new calibers. Truck is still pulling left. Any thoughts?
1 - 3 of 17 Posts
You said highway vibration when braking,usually a heat warp in a rotor.
Could be the one pulling left, if the pulling left has caused a heat build up.

I would inspect the left rotor and pads for oil/grease residue, nothing will grab a brake and harder, or faster than grease on a braking surface
Brakes on the trailer?

When the calipers were replaced, we're the pads replaced?
Listen to Jack
1 - 3 of 17 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.