GM Truck Club Forum banner

Replacing 1997 extended cab S-10 split shaft to solid shaft

11468 Views 4 Replies 3 Participants Last post by  Mechnix
Ok, need some help. I know some have replaced the S-10 split shaft with a solid driveshaft. I have a driveshaft company that will make me a one piece drive shaft, new U-joints, and use my existing ends for $250. I have replaced the carrier bearing, and the vibration has lessened, but still a little there around 60mph. I want to know and hear from some that have done this, how well did it work out for you? Problems, suggestions, best parts? I know there is a reason that GM made this truck with a split shaft, but I cannot find one problem with the one I have. I know, I know, may be your U-joints, but at $25 each and my truck uses 5, if that doesn't fix it, what next? Is there something else I may want to look at? I own a 1997 S-10 extended cab 2 wheel drive with a 4.3, auto. Thanks for any help.....:great:

Also, I pull a 8x6 enclosed trailer all the time and the truck has 153k. Even without the trailer, it's still there.
1 - 1 of 5 Posts
I don't think they would go to 2 piece shaft if there wasn't a very good reason, it costs a lot more
1 - 1 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.