GM Truck Club Forum banner

rough country 4.75 lift.

9830 Views 8 Replies 4 Participants Last post by  Rockstarrchevy81
the rough country 4.75 inch lift kit says backspacing 5.5 - 6 inches. will the stock rims fit on the truck with that lift kit installed?
1 - 1 of 9 Posts
i also heard that a proper alignment cannot be done on a truck with that rough country kit on it. true or false?
There is some truth to that. A whole lot of folks have had terrible issues with RC's 3" kit, which they now refer to as the re-engineered 3.5" kit. The kits wouldn't hold alignment due to the UCA's contacting the coils and the BJ's going out. The kit was total trash. I had one and it lasted about 2 months. After my experience combined with all of the bad experiences of others that I've read about, I wouldn't touch that kit. I did the install on my old 3" kit too and nothing lined up right. Personally I wouldn't consider it.
1 - 1 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top