GM Truck Club Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
14 Posts
Discussion Starter · #1 ·
Ill get ya up to speed, I built a 4th order center console for my 03 silverado, went out to install it and removed both seats unhooked all the plugs, removed the jump seat/center console, put in the new box, hooked up all plugs and put the seats back in. Went to pull the truck around front and when I started it "service air bag" message came up.

Now is this something to worry about or no?? I was thinking maybe I could disconnect the ground from the battery for a few seconds and reset it? is that feasible.

Thanks,

Tim
 

· Registered
Joined
·
1,224 Posts
Ill get ya up to speed, I built a 4th order center console for my 03 silverado, went out to install it and removed both seats unhooked all the plugs, removed the jump seat/center console, put in the new box, hooked up all plugs and put the seats back in. Went to pull the truck around front and when I started it "service air bag" message came up.

Now is this something to worry about or no?? I was thinking maybe I could disconnect the ground from the battery for a few seconds and reset it? is that feasible.

Thanks,

Tim
Yes, you could try disconnecting the battery to see if that resets it. alos make sure all the connections are good.

I would love to see the console also.....I have a 7th order blow through.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top