Also, did you reset your computer by disconnecting the battery? If not, you may want to give that a shot as well. I'm not sure if it works for ABS but it does for regular codes.
Stubborn ABS light
stubborn ABS warning light from hell
its 1993, so its OBD 1
no codes in the computer. when you hard wire the access port, the pump turns on and works.
i have reset the computer every way i could think of. i even completely unplugged the ABS pump while resetting the computer.
the light does not turn off!
any suggestions before i put electrical tape over the warning light?
the really messed up thing, is that it stops better when all the wheels lock... but i havent tested that on ice yet...
its 1993, so its OBD 1
no codes in the computer. when you hard wire the access port, the pump turns on and works.
i have reset the computer every way i could think of. i even completely unplugged the ABS pump while resetting the computer.
the light does not turn off!
any suggestions before i put electrical tape over the warning light?
the really messed up thing, is that it stops better when all the wheels lock... but i havent tested that on ice yet...
1 - 1 of 4 Posts
1 - 1 of 4 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
GM Truck Club Forum
A forum community dedicated to all General Motors truck owners and enthusiasts. Come join the discussion about performance, lift kits, wheels, tires, modifications, troubleshooting, maintenance, and more!
Full Forum Listing
