GM Truck Club Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I am currently building my '72 Blazer. I am putting 4" springs front and rear. I am puttin' the throttled body 350, 700R4 and NP208 from my '91 Blazer into the '72 blazer. I have everything squared away but I am stuck on the speedometer. My '91 is electronic and my '72 is mechanical. I have built a few truck in the past 10 years, but this is my first time putting a fuel injected engine in an older mechanical fueled vehicle. Does anybody know of a way around my speedometer problem that wont cost me 300.00 or more dollars?
 

·
Moderator
Joined
·
4,774 Posts
Welcome to the Site.......As this is the Member Introduction Section of the forum, it where you tell the other member's a little about yourself and your Ride.......Your question Regarding Speedometer Conversion, will Receive more Advice/Help under the Tech Section of the Forum.....
 

·
Registered
Joined
·
7,172 Posts
Welcome to the Club!!! x2 on posting on the Tech Q&A (if you have not done so already), as many of us who participate in Members Intro area are not techs/mechs. I wish I could help you, but I am definitely not qualified. Good-Luck!!!
 

·
Registered
Joined
·
2,050 Posts
Welcome aboard! Definitely post in the tech sections. You will get a lot of help I am sure. Illinois really that bad?
 
1 - 4 of 4 Posts
Top