GM Truck Club Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter · #1 ·
Does anyone know what setting the torsion bars are at when the truck is stock. I am returning my truck to stock tires after 3 years of running 285/75/16's. I reacently learned that the tire store where I bought the tires cranked up the bars to make the tires fit. The ride has sucked all this time and now I know why. Thanks
 

·
Registered
Joined
·
2,428 Posts
I haven't played with the torsion bars on my burb. It had the lift kit when I bought it. There is a good article on torsion bars at: Offroad-Tech
The ride is pretty rough on the burb so if I can get the time I might try loosening the torsion bars to improve the ride.
 

·
Registered
Joined
·
2,805 Posts
well you dont know how much they cranked them so maybe just try cranking them down an inch at first and if it still sucks than try another half inch.... its gonna be tedious and could get annoying but it may be your only bet
 

·
Registered
Joined
·
9 Posts
Discussion Starter · #4 ·
Thanks for the replies. I have been adjusting them but it always looks like the drivers side is lower than the other. I have tried measuring but that does'nt seem to work. I might take it in and get an alighnment and ask the shop to adjust them.
 

·
Registered
Joined
·
592 Posts
Thanks for the replies. I have been adjusting them but it always looks like the drivers side is lower than the other. I have tried measuring but that does'nt seem to work. I might take it in and get an alighnment and ask the shop to adjust them.
Yeah, do that. :) The alignment shop would have better luck with that adjustment than you would. And they need to align it anyways.
 
1 - 5 of 5 Posts
Top