GM Truck Club Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
After doing some research I’ve decided to install some 5100 Benstein shocks in the front and rear I’m also going to be replacing the ball joints upper and lower control arms with replacing the bushings what do y’all think about this type of upgrade it would most cost effective with getting the job done the current control arms are in good condition the bushings have just been worn out. So my plan is to upgrade the bushings and replace all 4 ball joints with high quality parts also installing the 5100 lmk what y’all think
 
1 - 1 of 1 Posts
Top