GM Truck Club Forum banner

Vortec 8100 Cyl Head bolt pattern [Expired Topic] [Expired Topic]

2013 Views 3 Replies 3 Participants Last post by  gmcjohnny
From what I'm reading, (and admittedly it could be wrong) the only differences between the 7.4L and the 8.1L (8100) engines are in the stroke of the cyl. Does anyone know if there was a design change in the bolt pattern of the heads? I'm thinking it would be easier just to increase the stroke, and not retool the heads, but I don't design engines.
Status
Not open for further replies.
1 - 4 of 4 Posts
RE: Vortec 8100 Cyl Head bolt pattern

maybe go down to your local parts store and compare head gasket betwen the 2??
RE: Vortec 8100 Cyl Head bolt pattern

Good idea. I wasn't actually going to act on it. I think it would be easier to find vrtoec 7400 heads, but it was just something that crossed my mind, and I wondered if anyone knew.
the 7.4 is alittle different then the 8.1 if you have 8.1 make sure 8.1 heads go back on intake an exhaust is spaced different when you go an put your intake an exhaust on you will see
1 - 4 of 4 Posts
Status
Not open for further replies.
Top