GM Truck Club Forum banner
1 - 1 of 1 Posts

· Registered
296 Posts
Discussion Starter · #1 ·
Looking to see if any techies out there know where the VSS wire, plug and pin are that run to the ECM and/or BCM on a 2007 GMT900, 5.3L 4L60E...

Reason being is I bought a speed calibrator and have it all wired except for the most important part, the VSS wire. My Bully Dog 3GT corrects for wheel/tire/gear size but the ECM doesn't recognize any gear ratio past 4.10, and I converted from stock 3.73 to 4.56/33"tires. Also there are schematics out for the 07 Classic trucks but I did some hunting and they are not wired the same as the newer body style trucks.

Any help is greatly appreciated!
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.