GM Truck Club Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
161 Posts
Discussion Starter #1
i am putting a CB radio in my truck.. my plan is to put the antennas on the sides of the tool box.. the only problem is how am i going to run the whires into the cab..should i drill a hole in the floor and run them up thru their??if i was to do that how would i seal up the hole??any help would be great :)
 

·
Premium Member
Joined
·
1,625 Posts
i am putting a CB radio in my truck.. my plan is to put the antennas on the sides of the tool box.. the only problem is how am i going to run the whires into the cab..should i drill a hole in the floor and run them up thru their??if i was to do that how would i seal up the hole??any help would be great :)
Drill is the cleanest.

Use a rubber gromet of the right size, and silicone it before putting it in.
 

·
Registered
Joined
·
2,630 Posts
If I wasn't interested in putting new holes in my rig, I would find one of the rubber body plugs, and punch a hole in it, feed the wire through, and then silicone the wire, and plug to keep the water out.

Otherwise I agree with 84Fiero.:cool:
 

·
Registered
Joined
·
161 Posts
Discussion Starter #4
ok so i should drill the hole..get like a gromit thing than i plug it??if i was to plug the hole how would the wire go thru? i know with my plow truck i just dont give a damn so idrilled a hole and left it its soo rusty i dont even have a bed their is just a huge hole in it..but i mean i want to do thisthing right bc i want to give it to my daughter someday
 
1 - 4 of 4 Posts
Top