GM Truck Club Forum banner

Wiring for Electric Trailer Brakes

13641 Views 9 Replies 5 Participants Last post by  BoneHead
Greetings:

Have a 1998 Suburban 1500 that I am wiring for electric trailer brakes. Have everything in but the wire that goes to the brake switch - can't get my old, fat hand up high enough to grab it. Since there is only one bulb (or set of wires that go to the brake light I can't run it to there. Does anyone have a tip or trick on where to connect the brake signal wire to? The vehicle does not have a heavy duty towing package - at least not that I can find. All it had was the four connector at the rear. For enticement some home made chipotle :great: chile powder for the right answer.

thanks - NMTROUT
1 - 5 of 10 Posts
Thanks Crawdaddy - I will go try it now. Greatly appreciate it - do you like Chipotle powder - made out of home grown peppers but no Jalapenos (Habaneros instead).
Absolutely awesome Kidhauler - many many thanks! Do you want Chipotle powder also (not too hot but keep it away from the kids)?
Thanks

Please - please send the mailing address to [email protected]. Then it is on it's way.

Thanks again - Ted Kircher in Albuquerque
TOTAL SUCCESS!!! KidHauler gave me information that even the dealership here had no idea on. He ROCKS!
1 - 5 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top